Pipetite® · Type
Flat
Low-profile seal for jacketed vessels, sheathed tanks, and tight penetrations where a standard cone boot is too tall.
1products
More Pipetite®
Other Pipetite® Types
7 productsStandard
Slips over the end of the pipe before installation — the default boot for new construction. Seven sizes, full-cone or precut.
Pipetite® Standard Wall BootPipetite Wall Boot — Size 1, Precut 0.75"
1 productReBoot®
Splits to wrap around a pipe that's already installed, then reseals — retrofit a penetration without cutting or pulling the line.
Pipetite® ReBoot Wall Boot
3 productsMulti-Grommet
Organizes and seals several cables or small tubes through one penetration — ideal for IT, electrical panels, and cleanroom cabling.
Pipetite PT1-MG Multi-Grommet — 0.25"–0.50"
3 productsSleeves, Grommets & Accessories
Sleeve boots, single grommets, pipe-in-pipe seals, and mounting anchors that round out the Pipetite system.
Sleeve Boot & Sleeve ReBootGrommet & Pipe-n-Pipe Seals
Stuck on a Part? Talk to a Real Engineer.
Most parts you can buy in two clicks. For everything else — bulk pricing, custom skids, spec questions — these lines reach an actual person.